1/4 Yard 45” Fabric (for header)
3/4 Yard 45” Fabric (for body)
Seam Allowance: 1/2”
Terms to know:
Selvage: The manufacturer’s edge of the fabric. Often copyright, color swatching and basic information is printed on the selvage. This edge is “sealed” and will not unravel like a raw edge or seam.
Raw Edge: Where the fabric has been cut
Raw Seam: Where the cut edges of two (or more) pieces of fabric have been sewn together
Straight Stitch: Quite simply, a series of stitches that make a straight line (——)
Overcasting: A zig-zig or actual stitch (see your manual) that is used to “seal off” a raw seam ( /\/\/\/\/\/\/\ or _/_/_/_/)
Step 1: Prepare the Header
Take the 1/4 yard of fabric and fold and press flat lengthwise with the pattern side out. You will have a long, thin strip of fabric that measures approx. 4.5 x 45 inches:
Step 2: Prepare the Body
Take the 3/4 yard of fabric and open it up and press. This will measure approx. 27 x 45 inches.
Step 3: Attach Header
Place the body piece down, fabric side up and place the header on top. Match the header to the body with raw edges together. If one piece is longer than the other, center shorter piece.
Pin the three edges together, going through all pieces of material and crossing the cut line with the pins. The point should face the raw edges.
Sew a straight stitch down the length of the header. Raw edges should be to the right. Remove pins.
Trim edge to approx. 1/4”. Then repeat by overcasting. Trim threads.
Step 4: Finish
Fold back the header and press.
Fold the pillow case in half with printed sides together (it should look like an inside-out pillow case now. Using a straight edge, trim off any excess fabric.
Pin the two sides with raw edges (it will be an “L” shape). Straight stitch and overcast as you did with the header. Trim threads.
Turn right side out and insert a fluffy pillow. Take a nap–you did it!